Making a recording 36, Making an audio or a video recording 36, Record monitor 36 – Pioneer VSX-D810S User Manual
Page 36: Making a digital recording 36, 08 making a recording, Making an audio or a video recording, Record monitor, Making a digital recording, 1 turn the, Buttons if the direct function is on)

36
En
08
Making a Recording
Making an Audio or a Video
Recording
The following steps show you how to make an audio or
a video recording from the built in tuner, or from an
audio or video source connected to the receiver (such as
a CD player or TV). Recordings can be made to a CD-R,
TAPE, MD, VCR, or DVR connected to the CD-R/TAPE/
MD, VCR or DVR in/out connectors.
1 Turn the
MULTI JOG dial
to select a source to
record (you can also use the
MULTI CONTROL
buttons if the DIRECT FUNCTION is on).
All functions except MONITOR are accessible from
the remote control.
2 Prepare the program source.
Tune to the radio station, load the CD, etc. For a
video recording load the video, DVD etc.
3 Insert a blank tape, MD, video etc. into the
recording device connected to either CD-R/
MD/TAPE or VCR/DVR and set the recording
levels.
Refer to the instructions that came with the recorder
if you are unsure how to do this. Most video record-
ers set the audio recording level automatically—
check your video's instruction manual if you are
unsure whether yours has manual controls.
4 Start recording, then start playback of the
source component.
MEMO:
The receiver's volume, TONE control (bass & treble)
LOUDNESS, MIDNIGHT, DIGITAL NR (VSX-D810S
only) and surround effects have no effect on the
recorded signal.
Record MONITOR
You can listen to (monitor) the recording as it's being
made using the
MONITOR
button on the front panel (a
cassette deck would have to have a record monitor
function).
Press the
MONITOR
button to switch between the
recorded signal and the original source signal.
Making a Digital Recording
The VSX-D710S has one optical digital output jack. If
you want to make a digital recording from this receiver
hook up the optical output on this receiver to the optical
input on the digital component you want to record into.
The source component (like MD, CD, DVD, etc.) must
be digital also, of course, and hooked up to this receiver
in a digital manner. Make sure the analog/digital switch
is set to digital (see p. 27) The recording procedure is
the same as described above.
Refer to the table below for the type of digital connections
available in each receiver model.
1
DISC
MPX
DISPLAY
RF ATT
D.ACCESS
CLASS
ATT
BAND
/DTS
DSP
TEST TONE
CH SELECT
CH LEVEL
FUNCTION
SIGNAL SELECT
1
¡
4
¢
7
8
3
¶
EFFECT
DVD
VCR
CD-R
TV
RCV
TUN
TVC
CD
MIDNIGHT
LOUDNESS
MUTING
SETUP
FL DIMMER
MULTI CONTROL
5.1 / 7.1
RECEIVER
SOURCE
1
2
3
4
5
6
7
8
10
9
0
2
1
N∫m-Û˘,?∫
MONITOR
1
MODEL
COAX IN
OPT IN
OPT OUT
VSX-D710S
1
2
1
VSX-D810S
1
3
1