Pioneer DBR-TF100 - Manual (Page 34)

Other options 08
34
Country
You select the country in which the DTR is
being used. Press
2/3 to select a country.
• If you change the country selected, the
channels available must be scanned
again. An alert is displayed asking if you
want to scan the channels again. Press
2/3 to select Yes and press SELECT.
(See Scanning for channels, page 13.)
Add New Channels
Select to add new channels to the channel
list.
Scanning starts. If new channels are found
they are added to the channel list. The num-
ber of new channels, if any, are displayed.
• To cancel scanning once it has started,
press EXIT. Scanning stops and a mes-
sage is displayed stating that scanning
has stopped.
Replace Existing Channels
Select to update information on channels
and delete channels that are no longer avail-
able.
Scanning starts. If new information about a
channel is found, the channel information
is updated. If some channels are no longer
available the channels are deleted.
• To cancel scanning once it has started,
press EXIT. Scanning stops and a mes-
sage is displayed stating that scanning
has stopped.
• If no channels were found, a message is
displayed asking you to check the aerial
connection.
Signal Check
Select to check the signal strength of each
channel. Press
2/3 to select a channel.
The signal strength is displayed numerically
and with words and is updated once every
second. Press
MENU to leave.
Software Update
The DTR can automatically download
software updates through the TV aerial. You
can set the options for the software update
in the Software Update menu. Follow these
steps to access the Software Update menu:
1 While viewing a programme, press
MENU. The HOME MENU is displayed.
2 Press 5/∞ to select Setup and press
SELECT. The Setup menu is displayed.