Pioneer DBR-TF100 - Manual (Page 14)

02
14
Basic operation
Chapter 4:
Basic operation
Turning on/off
To turn on, press STANDBY or any num-
ber buttons. When you press STANDBY
, the channel last viewed is tuned in. When
you press a
number button, the channel of
the number button is tuned in. Then the Info
banner is displayed and disappears after a
few seconds.
• You can remove the Info banner immedi-
ately by pressing EXIT.
To turn off, press STANDBY . The DTR
goes into standby mode.
Changing channels
Using the P +, – buttons
Press P +/– to change a channel up/down
from the list of available channels.
Hold down
P +/– to rapidly move through the
channel numbers until the desired channel
number is reached then release the button.
The channel is displayed.
Using the number buttons
Enter a 3-digit number for the desired chan-
nel. For example, if you want to tune in chan-
nel 125, enter 1-2-5.
Or
Enter just the digits of the number of the
channel desired. For example, if you want to
tune in channel 5, enter 5.
• If a channel is not available for the
channel number input, ‘No service is
available on this channel’ is displayed for
a few seconds and the channel does not
change.
Using the channel list
1 If you press SELECT while watching a
programme, a channel list of six channels,
including the present channel, is displayed.
2 Press 5/∞ to see lower or higher chan-
nels on the list.
• Press 2/3 to move to the previous/next
list of channels.
3 Press SELECT again to select a channel
to tune in.