83 en – Olympus TG810 User Manual
Page 83
83
EN
Warning
Warning
Unauthorized photographing or use of copyrighted material
may violate applicable copyright laws. Olympus assumes no
responsibility for unauthorized photographing, use or other acts
that infringe upon the rights of copyright owners.
Copyright Notice
Copyright Notice
All rights reserved. No part of these written materials or this
software may be reproduced or used in any form or by any
means, electronic or mechanical, including photocopying and
recording or the use of any type of information storage and
retrieval system, without the prior written permission of Olympus.
No liability is assumed with respect to the use of the information
contained in these written materials or software, or for damages
resulting from the use of the information contained therein.
Olympus reserves the right to alter the features and contents of
this publication or software without obligation or advance notice.
FCC Notice
FCC Notice
Radio and Television Interference
Changes or modifi cations not expressly approved by the
manufacturer may void the user’s authority to operate this
equipment. This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
Adjust or relocate the receiving antenna.
Increase the distance between the camera and receiver.
Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
Consult your dealer or an experienced radio/TV technician
for help. Only the OLYMPUS-supplied USB cable should
be used to connect the camera to USB enabled personal
computers (PC).
Any unauthorized changes or modifi cations to this equipment
would void the user’s authority to operate it.
•
•
•
•
•
•
•
•
Use Only Dedicated Rechargeable Battery,
Use Only Dedicated Rechargeable Battery,
Battery Charger and USB-AC adapter
Battery Charger and USB-AC adapter
We strongly recommend that you use only the genuine Olympus
dedicated rechargeable battery, battery charger and USB-AC
adapter with this camera. Using a non-genuine rechargeable
battery, battery charger and/or USB-AC adapter may result
in fi re or personal injury due to leakage, heating, ignition or
damage to the battery. Olympus does not assume any liability
for accidents or damage that may result from the use of a
battery, battery charger and/or USB-AC adapter that are not
genuine Olympus accessories.
For customers in North and South America
For customers in North and South America
For customers in USA
Declaration of Conformity
Model Number:
TG-810, TG-805
Trade Name:
OLYMPUS
Responsible Party:
Address:
3500 Corporate Parkway, P.O. Box 610,
Center Valley, PA 18034-0610, U.S.A.
Telephone Number:
484-896-5000
Tested To Comply With FCC Standards
FOR HOME OR OFFICE USE
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
For customers in CANADA
This Class B digital apparatus complies with Canadian ICES-003.
For TG-810 only:
Operation is subject to the following two conditions: (1) this
device may not cause interference , and (2) this device must
accept any interference , including interference that may cause
undesired operation of the device.
This Category II radiocommunication device complies with
Industry Canada Standard RSS -310.