Menu: system, Registration code, Registering the telephone to the dect system – Avaya 3701 User Manual
Page 37
Menu: System
Issue 3 October 2008
37
Menu: System
Registration Code
The telephone can be manually registered on up to 5 different DECT systems. Before you can
make a call via the DECT system, the telephone has to be registered to the system. A system
ID and registration code are necessary for the registration process. Ask the system
administrator for the valid registration code. When the telephone is not subscribed to the system
the display will show ”Please, subscribe”.
This is for information only. Please contact your System Administrator to register the telephone
All settings in this chapter are started by pressing the softkeys:
Menu
System OK
Registering the Telephone to the DECT System
Subscription OK >Subscribe HS< OK PABX-PIN
OK
- Subscribe OK
or
-
Use PARK-Code PARK
OK
or
-
Cancel OK
The following entries must be made when logging on:
PABX-PIN : this code is used to get access to the DECT System.
Use PARK-Code : a system ID should only be entered if you are at a location where two
DECT systems overlap.
Enter name : give the name of the DECT system to which you are registering. This will be
shown on the idle display. For information concerning the entry of characters, refer to
Internal No. : the phone number, assigned to your DECT telephone can be entered here
(ask your system administrator for the phone number).