Xerox iGen4 Digital Press con Xerox EX Print Server Powered by Fiery-16492 - Manual (Page 4)

Page 4
When you send an RDO (raster data object) file to the EX Print Server and insert tabs in
Command WorkStation, the tab text does not print correctly on the right-hand side. To avoid
this, insert tabs in FreeFlow Makeready or send the job to Command WorkStation as a PDF
(not RDO) file.
N OTE : The file must be saved with the .RDO extension. If you override the job name found in
Job Notes, make sure that the job name ends with the .RDO extension. An RDO file that
contains precut tabs must print to the EX Print Server Print queue or Hold queue. Also, if
you process and hold the job in Command WorkStation, the job will lose its precut tab
attributes and any text on the tabs will not print.
Command
WorkStation Instruction character length
If you send a job over IPP with the FreeFlow Special Instructions between 120 and 127
characters in length, you will get an error message and Command WorkStation must close. If
this error reoccurs, restart the EX Print Server. As a workaround, limit special instructions to
less than 120 characters.
Printing
FreeFlow Output Locations and EX Print Server Output Destinations
For information about how the FreeFlow Output Locations correspond to EX Print Server
Output Destinations, see the following table.
FreeFlow UI EX Print Server UI
Printer Default Printer’s Default
Top Tray Top Tray 1
Tray 2 Top Tray 2
Stacker HCS Stacker 1
Stacker 2 HCS Stacker 2
Finishing Bypass (a.k.a. External) HCS Bypass