Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-14668 - Manual (Page 5)

DocuSP Remote Services
Setup Guide
Version 50.XX
3
Section 2 Configuring Remote Services
__1. To open Remote Services, move the mouse to a blank area of the
workspace and press the [Help] key located at the upper-left corner or the
keyboard. The Remote Services Home window is displayed (Figure 5).
Figure 5 - Remote Services Home Window
Note:
A short delay (~30 seconds) may occur before the window opens.
__2. If the Registration window opens automatically, minimize it at this time. It is not
needed until later in the procedure.
__3. Select [Setup] at the bottom of the Remote Services Home window. The
Setup window is displayed.
__4. Confirm that the Print Engine Serial Number field displays the correct serial
number (Figure 6). If the field does not display the correct number, enter it
at this time, and then select [Apply New Settings].
Figure 6 - Checking the Serial Number
IMPORTANT!
If the correct serial number was not displayed in the General Setup
window, access dC105 System Configuration Setup and enter the
correct number at the completion of this setup procedure.
Print Engine Serial Number
Examples:
PYW123456 (NASG)
1121234567 (XE/DMO)