Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-14668 - Manual (Page 3)

DocuSP Remote Services
Setup Guide
Version 50.XX
1
Section 1 Before You Start …
Complete the following steps to ensure that the DocuSP DFE is configured
properly for Remote Services.
__1. Ensure that the DocuSP DFE is connected to the Customer’s network and
not ripping or printing jobs (idle).
__2. Ensure that the customer has purchased an FSMA Agreement.
__3. Locate the Remote Services Installation Worksheet in the product
installation planning document (Figure 1). Information provided by this
worksheet is critical for setup, and includes the following:
•
IP Address assigned to the Customer’s product
•
Name Service information (if applicable)
•
Proxy IP Address and Port (if applicable)
•
User Name and Password for firewall/proxy access (if applicable).
Figure 1 –Sample Installation Worksheet for Remote Services
__4. Login as System Administrator at the DocuSP GUI. Select
[Administration], and then select [Accounting...]. Select [Options...] to
open the Accounting Options window (Figure 2). Ensure the options are
configured for Remote Services to function properly.
Figure 2 – Accounting Options Window
__5. If the Customer’s network uses a Name Service, ensure it is enabled in the
DocuSP application.
To check DNS setup, select [Setup: Network Configuration: DNS] at the
UI to display the DNS settings (Figure 3). Refer to the Installation
Worksheet, and enter the information.
Installation Worksheet
Disable
Enable
Disable