Konica Minolta Magicolor 2480MF - Manual (Page 38)

Print Media 26
"
Keep media between 35% and 85% relative humidity. Toner does
not adhere well to moist or wet media.
„ Layered
„ Adhesive
„ Folded, creased, curled, embossed, warped, or wrinkled
„ Perforated, three-hole punched, or torn
„ Too slick, too coarse, or too textured
„ Different in texture (roughness) on the front and back
„ Too thin or too thick
„ Stuck together with static electricity
„ Composed of foil or gilt; too luminous
„ Heat sensitive or cannot withstand the fusing temperature (180°C
[356°F])
„ Irregularly shaped (not rectangular or not cut at right angles)
„ Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
„ Acidic
„ Any other media that is not approved
Card Stock
Paper thicker than 90 g/m 2 (24 lb bond) is referred to as card stock. Test all
card stock to ensure acceptable performance and to ensure that the image
does not shift.
You can print continuously with card stock. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
"
43 lb bond is also referred to as 90 lb index stock.
Capacity Tray 1 Up to 50 sheets, depending on their thick-
ness
Tray 2 Not supported
Driver
Media Type Cardstock
Weight 91 to 163 g/m² (25 to 43 lb bond)
Duplexing Not supported