Konica Minolta bizhub 601 - Manual (Page 69)

751/601 1-56
Setup items by operation 1
1.16 Receiving Internet faxes
Specify settings for receiving Internet faxes.
In order to use the Internet fax function, this machine is required to be equipped optionally with a hard disk
and an image controller. And when using the Internet fax function, settings by a service engineer are required.
For details, contact your service representative.
The Internet fax function sends and receives scanned originals as an attached file (TIFF format) via the
intranet (internal company networks) or Internet. This via-intranet or -Internet communication largely reduces
the communication cost as compared with general fax messages.
Performing APOP authentication when receiving an Internet fax ensures safer communication.
Specify the settings according to the following flowchart.
2
Note
For details on registering Internet fax addresses, refer to "Registering or editing an address book
destination" on page 1-168 .
For details on the Internet fax operation, refer to the User’s Guide [Network Scan/Fax/Network Fax
Operations].
1.16.1 TCP/IP Settings
Specify settings to use this machine in a TCP/IP network environment.
For details, refer to "Specifying general settings for TCP/IP-based communication" on page 1-2 .
1.16.2 Internet Fax Function
Enable the Internet fax function of this machine.
For details, refer to "Internet Fax Function" on page 1-50 .
TCP/IP Settings
Internet Fax Function
E-mail RX (POP)
I-Fax Advance Setting
Communicate with the POP
server using SSL?
APOP?
Yes No Yes No
POP over SSL APOP Authentication
Finish