Konica Minolta bizhub 601 - Manual (Page 62)

751/601 1-49
Setup items by operation 1
1.15 Sending an Internet fax
Specify settings for sending an Internet fax.
In order to use the Internet fax function, this machine is required to be equipped optionally with a hard disk
and an image controller. And when using the Internet fax function, settings by a service engineer are required.
For details, contact your service representative.
The Internet fax function sends and receives scanned originals as an attached file (TIFF format) via the
intranet or Internet. This via-intranet or -Internet communication largely reduces the communication cost as
compared with general fax messages.
Communication by combining POP before SMTP, APOP, SMTP authentication or encryption using SSL/TLS
is available. For details, refer to
"Sending scan data by E-mail" on page 1-25 .
Specify the settings according to the following flowchart.
2
Note
For details on registering Internet fax addresses, refer to "Registering or editing an address book
destination" on page 1-168 .
For details on the Internet fax operation, refer to the User’s Guide [Network Scan/Fax/Network Fax
Operations].
TCP/IP Settings
Internet Fax Function
Regist machine informa-
tion
Header Information
E-mail TX (SMTP)
I-Fax Advanced Setting
Communicate with the SMTP
server using SSL/TLS?
SMTP Authentication? POP before SMTP?
Yes No Yes No Yes No
SMTP over SSL/Start TLS SMTP Authentication POP before SMTP
➀ POP over SSL?
➁ APOP?
No Yes
➀ POP over SSL
➁ APOP Authentication
Finish