Konica Minolta bizhub C550 - Manual (Page 81)

Scanning 2
C550 2-42
3
Type in the address of the destination, and then touch [OK].
– To specify additional destinations, repeat steps 2 and 3.
– Frequently entered user names and domain names can be regis-
tered to be recalled and used again. First, prefixes and suffixes
must be registered in Administrator mode.
The entered addresses appear under “Broadcast Destinations”.
4
Touch [Scan Settings], [Original Settings] or [Communication Settings],
and then specify the desired scan settings.
– For details on the scan settings, refer to “Specifying scan and
transmission settings (Scan Settings/Original Settings/Communi-
cation Settings)” on page 2-75.
5
Load the document into the ADF or place it on the original glass.
6
If desired, press the [Proof Copy] key to check a preview image.
– For details, refer to “Sending after previewing” on page 2-20.
7
Press the [Start] key in the control panel.
Scanning of the document begins, and the data is sent.
2
Note
Do not turn off the machine until the scan job is deleted from the Job List
screen.