Konica Minolta bizhub C353 - Manual (Page 65)

C353/C253/C203 2-36
Using copy functions 2
2.11.3 Selecting a Paper Size setting
The paper size can be set for the paper tray so that it can be used with the
specified paper size.
2
Note
For details on loading paper, refer to the User’s Guide [Copy Operations].
The paper size can be selected for the bypass tray in any of the following ways.
*1
Settings can be specified for trays 1 and 2. When the optional single paper
feed cabinet or double paper feed cabinet is installed, settings can be also
specified for trays 3 and 4. In addition, [12-1/4×18 w] is available for the
tray 2.
*2
If paper other than the specified paper size is loaded, a paper misfeed may
occur since the paper size is not automatically detected.
*3
In order to specify a custom paper size in Enlarge Display mode, the
custom paper size must first be stored before entering Enlarge Display
mode. For details, refer to the User’s Guide [Copy Operations].
*4
By specifying paper one size larger than the document as wide paper, the
document can be copied at the center so that there is no loss of the
document image.
The following procedure describes how to specify the size of the paper loaded
into the bypass tray.
Setting Description
Auto Detect
*1
Select this setting to automatically detect the size of the paper loaded
into the bypass tray.
Metric Sizes
*2
A metric paper size can be set so that the paper tray is used specifically
with the selected paper size.
Inch Sizes
*2
A paper size in inches can be set so that the paper tray is used
specifically with the selected paper size.
Other
*2
A paper size other than the preset metric and inch sizes can be set so
that the paper tray is used specifically with the selected paper size.
Custom Size
*3
A custom paper size can be set so that the paper tray is used
specifically with the selected paper size.
Wide Paper
*1*4
A wide paper size can be set so that the paper tray is used specifically
with the selected paper size.