Konica Minolta bizhub C352 - Manual (Page 126)

Specifying settings from the control panel 3
C352 3-15
Sp
ecifying
se
tt
ing
s
f
ro
m
th
e cont
ro
l pan
el
Chapter 3
16
Touch [OK].
17
Press the [C] (clear) key to erase the value, and then use the keypad to
type in the port number (between 1 and 65535).
– To enable PASV mode, touch [PASV Mode].
– To use a proxy server, touch [Proxy].
– If a value outside of the allowable range is specified, the message
“Input Error” appears. Type in a value within the allowable range.
18
Touch [OK].
The FTP destination is registered.
2
Note
The registration cannot be completed unless settings have been speci-
fied for “Name”, “Host Address”, “File Path”, “User ID”, and “Password”.
!
Detail
To check the registered destination, touch the button for the destination,
and then touch [Check Setting].
To change the registered destination settings, touch the button for the
desired destination, and then touch [Edit].
To delete the registered destination, touch the button for the desired des-
tination, and then touch [Delete].
2
Note
To cancel changes to the setting, touch [Cancel].
To quit specifying the Utility mode setting, touch [Exit] in the sub display
area or press the [Utility/Counter] key. Otherwise, cancel the Utility mode
by touching [Close] in each screen until the screen for the Copy, Fax,
Scan or Box mode appears.
!
Detail
For the procedure to enter characters, refer to “Entering text” on
page 6-5.