ATTO Technology Diamond Storage Array S-Class - Manual (Page 96)

85
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
10.2 Resetting Defaults
Resetting the Diamond Storage Array to defaults will not alter the RAID configuration, IP configuration
or Telnet information. However, resetting the Diamond Storage Array to factory defaults is a last-ditch
effort to recover from corrupt configurations or complete failure. All data will be lost.
Default
If you need to return to the default settings of the
Diamond Storage Array but do not want to lose
data or Ethernet settings, use the CLI command
RestoreConfiguration default in the CLI or in the
Advanced CLI Configuration page in the
ExpressNAV interface.
To return to Default settings
1 Connect to Diamond Storage Array services via
the RS-232 port or the optional Ethernet
management services card (refer to
Accessing
the Array on page 17). You should now be in
Command Line Interface.
2 Continue with the CLI or access the Advanced
CLI page of the ExpressNAV interface (refer to
ATTO ExpressNAV: Browser-based Interface on
page 25).
Note
Because the ExpressNAV pages take you
through this process easily, the following
instructions are based on the CLI commands.
Use these instructions as a guide in
ExpressNAV.
3 Type RestoreConfiguration default to reset
the system configuration (See Exhibit 10.2-1
for a list of configurations which will be
changed).
4 Type FirmwareRestart or cycle power of the
Diamond Storage Array.
5 Reboot the host PC after the Diamond Storage
Array completes its power on cycle.
Factory Default
Resetting the Diamond Storage Array to factory
defaults is a last-ditch effort to recover from
corrupt configurations or complete failure. All
data will be lost.
CAUTION CAUTION
Data will be lost if you follow these
procedures. Make sure you have no other
choice before resetting the Diamond
Storage Array to factory defaults.
To reset to factory defaults
firmware version 2.5.3 or higher
1 Connect to Diamond Storage Array services via
the RS-232 port or the optional Ethernet
management services card (refer to
Accessing
the Array on page 17). You should now be in
Command Line Interface.
2 Continue with the CLI or access the Advanced
CLI Configuration page of the ExpressNAV
interface (refer to
ATTO ExpressNAV: Browser-
based Interface on page 25).
Note
Because the ExpressNAV pages take you
through this process easily, the following
instructions are based on the CLI commands.
Use these instructions as a guide in
ExpressNAV.
3 Type RestoreConfiguration factorydefault to
reset the system configuration. (See
Exhibit 10.2-1 for a list of configurations which
will be changed).
4 Type FirmwareRestart or cycle power.
5 Reboot the host PC after the Diamond Storage
Array completes its power on cycle.