Anritsu MP1763C - Manual (Page 58)

4-24
Section 4 OPERATING INSTRUCTIONS
4.4.2 File recall
Insert the floppy disk into the floppy disk drive and select
the DIR mode. If the floppy disk is changed, always ex-
ecute a DIR command.
Check whither there is a file on the disk by pressing the
keys. If there is a file on the disk, only that file
name is displayed. However, if there is no file on the disk,
“– –” is displayed.
Call the contents of the file by pressing the RECALL key.
4.4.3 Disk formatting
Insert a unformatted disk into the floppy disk drive.
Don't care. (Both PATT and OTHERS mode are pos-
sible).
Select the FILE No. mode.
Display “Fr” by holding down the key.
(Fr follows 99)
Select the SHIFT mode.
When the DELETE key is pressed, formatting begins.
Note: The FUNCTION switch on the rear of the instru-
ment can be used for switching the format between
1440 KB/720 KB and 1232 KB/640 KB.