Seiwa SWRx series - Manual (Page 5)

7 User Manual
About this User Manual
INTRODUCTION
Your RADAR consists of two main components, the RADAR scanner unit and a
Chart Plotter display unit. The display unit is a user-supplied plotter capable of
running the Radar operating application. The RADAR scanner unit includes the
radar antenna, transmitter, receiver and necessary electronics to deliver Radar
information to the user’s chart plotter. The mounting hardware kit, interconnec-
tion cable and a Radar junction box are included in the Radar scanner box.
Any menu operation and functions activation in this User Manual is related to the
following chart plotter models (see the following table). Whenever it is necessary,
a note has been inserted for those models with operational differences.
CHART PLOTTER NAME SOFTWARE SN Radar Serial Port Available from Sw
SW701e S4x2SW8wc All 2 or 5 16.00
SW701i S4x2SW8wc All 2 or 5 16.00
SW701ce S4x2SW8wc All 2 or 5 16.00
SW701ci S4x2SW8wc All 2 or 5 16.00
SW1101 S5e2SW11c All 2 or 5 16.00
EXPLORER 3 S5egSWctc All 2 or 5 11.00
SEAWAVE 3 S5egSW12c All 2 or 5 11.00
MARLIN S5egSW15c All 2 or 5 11.00
The Radar full functionality, as described in this User Manual, is obtained only
when the scanner is included in an integrated system including chart plotter,
gyrocompass and GPS antenna.
Please read carefully this User Manual to learn the operating features for your Radar.
Please refer to your chart plotter User Manual for all other operating instructions.
CONVENTIONS USED
Throughout this User Manual, the labelled keys are shown in capital letters en-
closed in square brackets, for example [ENTER]; the software/function keys are
shown in small letters enclosed in square brackets, for example [Edit].
Menu operations are in bold characters listed by keys sequence with the menu
names enclosed between inverted commas, for example [MENU] + "ALARMS"
+ [ENTER] means: press the [MENU] key, using the cursor key select the Alarms
menu and then press [ENTER].
HOW THIS USER MANUAL IS ORGANIZED
♦
CHAPTER 1: Radar Installation
Installation of the Radar and set up of the hardware configuration.
♦
CHAPTER 2: Functions
How to connect the chart plotter and the Radar; and how to operate
them.