Seiwa SWRx series - Manual (Page 26)

28 User Manual
2.3.6.1 Handling of EBL/VRM
Positioning the Cross Cursor on the EBL/VRM activates a pop up message "E/V"
underneath the cursor. It is possible to allow to move, hook, edit and hide it.
♦
[Move] 1 : Allows moving EBL/VRM from the own ship's position to any
location of the Radar page. Pressing [Confirm] 1 confirms the new
position; pressing [Cancel] 1 resets the original position.
NOTE 1 F
OR SEAWAVE 3 , press [1, Move]. Then press [1, Confirm] or [2, Cancel].
♦
[Hook] 1 : hooks the EBL/VRM cross point allowing changing bearing
and range using the Cursor Keys. Pressing [Confirm] 1 confirms the
new range and bearing, pressing [Cancel] 1 resets the original range
and bearing values.
NOTE 1 F
OR SEAWAVE 3 , press [2, Hook]. Then press [1, Confirm] or [2, Cancel].
♦
[Edit] 1 : opens an edit window to change the Offset, Angle, Range and
Bearing values. Pressing [OK] 1 confirms the new values.
NOTE 1 F
OR SEAWAVE 3 , press [3, Edit]. Then press [1, OK].
♦
[Off] 1 : disables the EBL/VRM.
NOTE 1 F
OR SEAWAVE 3 , press [4, Off].
2.3.7 Parallel Cursor
A set of parallel lines with first line passing through the ship’s position and next
lines being placed equally spaced and extending from the ship’s position towards
one direction.
Parallel Cursor
Fig. 2.3.7 - Parallel Cursor display
The user can change the angle of the lines and the range between lines. It is used
to measure the bearing of other boats, navigate at a fixed distance from the
coast, measure the distance between two points.
The display of the Parallel Cursor can be turned On or Off following this procedure:
[MENU] + "Radar Features" + [ENTER] + "Parallel Cursor" + [ENTER] +
"On"/"Off" + [ENTER]
2.3.7.1 Handling of Parallel Cursor
Positioning the Cross Cursor on the first line (passing through the ship’s position)
activates a pop up message "///" underneath the cursor.
The following software/function keys are automatically displayed: