Seiwa SWRx series - Manual (Page 27)

29 User Manual
♦
[Hook] 1 : hooks the Parallel Cursor allowing changing the angle of the
lines and the range between lines using the Cursor Keys. Pressing
[Confirm] 1 confirms the new angle and range, pressing [Cancel] 1 resets
the original angle and range values.
NOTE 1 F
OR SEAWAVE 3 , press [1, Hook]. Then press [1, Confirm] or [2, Cancel].
♦
[Edit] 1 : opens an edit window to change the Range and Bearing values.
Pressing [OK] 1 confirms the new values.
NOTE 1 F
OR SEAWAVE 3 , press [2, Edit]. Then press [1, OK].
♦
[Off] 1 : disables the Parallel Cursor.
NOTE 1 F
OR SEAWAVE 3 , press [3, Off].
2.3.8 Center Offset
Allows to move the Radar center in any location of the screen.
To set the Center Offset follow this procedure:
[MENU] + "Radar Features" + [ENTER] + "Center Offset" + [ENTER] + insert
the desired value + [ENTER]
2.3.8.1 Handling of Center Offset
If the Radar is in Relative Motion mode, positioning the Cross Cursor on the
center of the Radar image, allows editing the Center Offset ("CTR" message is
shown under the cursor position). The software/function keys are automatically
displayed:
♦
[Move] 1 : hooks the Radar image center allowing the user, using the
Cursor Keys, to move it at any location on the Radar screen. At this
point pressing [Confirm] 1 confirms the new position of the center,
pressing [Cancel] 1 resets the position of the Radar image at 0,0.
NOTE 1 F
OR SEAWAVE 3 , press [1, Move]. Then press [1, Confirm] or [2, Cancel].
♦
[Offsets] 1 : opens an edit window where it is possible to edit the X
Offset and Y Offset position in pixel at which the center of the screen is
positioned. Pressing [OK] 1 confirms the new values.
NOTE 1 F
OR SEAWAVE 3 , press [2, Offsets]. Then press [1, OK].
♦
[Ctr.Scrn] 1 : resets screen offset position to 0,0.
NOTE 1 F
OR SEAWAVE 3 , press [3, Ctr.Scrn].
NOTE In True Motion mode the user cannot change the screen center position.
2.3.9 AIS Target
To enable (On) or disable (Off) the display of AIS Target follow this procedure:
[MENU] + "Radar Features" + [ENTER] + "AIS Target" + [ENTER] + "On"/
"Off" + [ENTER]
2.4 CHART FEATURES
2.4.1 Chart Overlay Mode
Selects which cartographic objects are to be displayed when Chart Overlay func-
tion is active in Radar Full page.
The following chart presets shall be available:
♦
Full: Full cartographic representation.
♦
Medium: includes “Low” settings plus Ports & Services and Auto Chart Boundaries.
♦
Low: includes also area fills, important city names, Nav-Aids & Lights and