Revolabs Fusion Setup Guide - Manual (Page 20)

Tabletop Master Mute
Setting the Mute Option
Individual Muting (default)
In the default setting, each Solo microphone will mute only itself when its mute
button on the microphone is pressed. To mute all of the microphones, press
the red MUTE button on the Remote Control; all microphones will flash red
and no individual microphone can be unmuted until the remote MUTE button is
pressed again. All microphones will return to their prior state. DIP switch #5
is OFF (page 18).
Tabletop Microphone Master Mute
In addition to the Remote Control MUTE button muting all of the microphones,
the Solo Tabletop microphone MUTE button will also act as a master mute and
mute all active microphones. Pressing any Tabletop microphone MUTE button
or the Remote Control MUTE button will unmute all tabletop microphones.
All wearable and handheld adapter microphones in use will return to their prior
state. DIP switch #5 is ON (page 18).
NOTE: The Fusion system must be powered off and back on for any
DIP Switch changes to take effect.
Page 20
Set-Up Guide