Revolabs Hybrid HD Microphones and Hybrid XLR Adapter - Manual

Revolabs Hybrid HD Microphones
and Hybrid XLR Adapter
Installing the Revolabs Hybrid HD Microphone or XLR Adapter
is easy. Simply plug the power supply into a power outlet,
connect it to the hybrid power adapter, and plug the
microphone into the power adapter. The Hybrid Microphone
or XLR Adapter will power on and be ready for use. Hybrid
Microphones and XLR Adapters are always ac ve and charging
while in the power adapter. A er roughly 2 hours in the
charger the microphone ba ery will have a full charge. At
that me the microphone can be removed from the power
adapter as required.
Permanently installing the Hybrid Microphones
Use the provided wipe to clean the bo om of the hybrid
microphone power adapter. When dry, a ach the provided tape
to the bo om.
Clean the surface on which you want to place the hybrid
microphone with approved cleaning material. Place the
microphone in the power adapter before removing the protec ve
cover from the tape and a aching it to the surface. Provide slight
pressure to the power adapter for about 60 seconds to ensure the
tape connects with the underlying surface. Hold the charger securely while a aching
the power cord. Let the adhesive cure for 24 hours before taking the microphone out of
the charger.
Pairing Hybrid Microphones
To pair the hybrid microphone to the HD receiver, you will need to turn off the
microphone. To turn off the microphone or XLR adapter, take it out of the power
adapter and then hold down the mul func on bu on un l the LED on the microphone
turns constant red. Release the bu on—the microphone is now turned off.
Once the microphone is turned off , press the mul func on bu on and hold it down
un l the LED turns constant red. The microphone is now in pairing mode. Bring the HD
receiver into pairing mode as well. Once the microphone and the receiver are paired,
the microphone LED will either blink green (unmuted) or red (muted).
Revolabs © 2012 07‐HYB‐DOC