Revolabs HD Venue Basic Setup Card - Manual

How to Configure Basic Settings
Refer to HD Venue User and Set-up Guide on www.revolabs.com
Technical Support 9:00 a.m. to 5:00 p.m. EST 1–800–326–1088
[email protected] www.revolabs.com
DIP Switch Feature Off (Default) On
1 Output Mixing Individual Outputs Mixed Output
2 Low Pass Filter No LPF LPF
3 Audio Output Level Line Level Mic Level
4 Mute Local Mute No Local Mute
5 Sharing Mode
Not Sharing: all
frequencies will be
used
Sharing: ½
frequencies will be
used
6 A/B Frequencies A Frequencies B Frequencies
300' 150' 75' 25'
7 Transmit Power Off On Off On
8 Transmit Power Off Off On On
Regulatory Information can be found in User Guide
1. Channel LED indicators: Displays microphone mute and pairing states
2. Pairing Push Buttons: For pairing microphones to Base Station
3. Antennae
4. Female XLR and ¼” Balanced Combo Input Connectors
5. Female ¼” Balanced Output Connectors
6. Male XLR Balanced Output Connectors
7. Mini-USB Serial Interface (firmware updates only)
8. Configuration DIP Switches
9. Power In Locking Receptacle (5VDC)
1 2 3
4 5 6 7 8 9
1 2 3 4 5 6 7 8
on
off
Universal power supply
plus plug
Quantity 2
Technical Support 9:00 a.m. to 5:00 p.m. EST 1–800–326–1088
[email protected] www.revolabs.com
Rack-mountable HD Venue Base Station with 2 Diversity Antenna (shown attached)
Charger Base
USB Cable for Firmware
Upgrades
How to Assemble
1. Rack-mount HD Venue Base Station
2. Attach the diversity antennas (2 SMA female connectors)
3. Plug the power supply into Base Station and appropriate electrical outlet
4. Plug cables into AV equipment
5. Plug power supply into Charger Base and appropriate electrical outlet
6. Pair Revolabs Wireless Microphones to Base Station using the pairing
instructions
7. Place microphones into Charger Base
8. Download firmware updates from www.revolabs.com/downloads
PHANTOM POWER MUST BE OFF. PHANTOM POWER MAY CAUSE
DAMAGE TO THE BASE STATION
Box Contents
NOTE: Revolabs Wireless Microphones Ship in Separate Boxes