Revolabs HD Single & Dual Channel System — Polycom VSX 8000 User Manual
Revolabs Equipment
Revolabs HD Single / Dual Channel System — Polycom VSX 8000 Setup Guide
This setup guide will guide you through the steps needed to properly connect a
Revolabs HD Single or Dual Channel System to a Polycom VSX 8000 video codec.
Note:
It is important to carefully follow these instructions in order and completely.
Otherwise your Revolabs Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs HD Single or Dual Channel System
2. Polycom VSX 8000 video codec
3. QTY 1 3.5mm balanced male connector to 3-pin mini Phoenix connector
cable*
* 07-35MBTOMPHX-01 6’ 3.5mm balanced male connector to 3-pin mini
Phoenix connector cable available from Revolabs
3.5MM STEREO MALE TO PHOENIX CONNECTOR CABLE DIAGRAM
Revolabs either recommends using the Revolabs 07-35MBTOMPHX-01 6’ 3.5mm balanced
male connector to 3-pin mini Phoenix connector cable, or cutting the end off an 1/8” cable and
attaching the green Phoenix connector as shown above.