MSI X2-109 v1 - Manual (Page 70)

4-18 MegaCLI Command Tool
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
4.9.3 Set Physical Disk Drive State to Offline
Use the command in Table 4.29 to set the state of a physical disk drive
to Offline. In the offline state, the logical drive is not available to the
adapter.
4.9.4 Set Physical Disk Drive State to Unconfigured-Good
Use the command in Table 4.30 to set the state of a physical disk drive
from Unconfigured-Bad to Unconfigured-Good.
4.9.5 Manage Global Hotspares
Use the command in Table 4.31 to manage the configuration and
assignment of global hotspares . Make sure the capacity of the hotspare
drive is equal to or larger than the capacity of the disks in the array and
that it is the same type of drive (SAS or SATA).
Note: The hotspare drive will rebuild a failed drive even if it is
SAS and the array drives are SATA, or vice versa. Once
the rebuild is completed, LSI recommends that you replace
the new array member with a drive of the same type.
4.9.6 Rebuild Physical Disk Drive
Use the command in Table 4.32 to start or stop a rebuild on a physical
disk drive and display the rebuild progress. When a physical disk in an
Table 4.29 Set Physical Disk Drive State to Offline
Syntax CmdTool –PDOffline -PhysDrv[E0:S....] -aN|-a0,1,2|-aALL
Description Changes the physical disk drive state to Offline.
Table 4.30 Set Physical Disk Drive State to Unconfigured-Good
Syntax CmdTool –PDMakeGood -PhysDrv[E0:Sn...] -aN|-a0,1,2|-aALL
Description Changes the physical disk drive state from Unconfigured-Bad to Unconfigured-Good.
Table 4.31 Manage Hotspares
Syntax CmdTool –PDHSP {–Set} -Rmv -PhysDrv[E0:Sn....] -aN|-a0,1,2|-aALL
Description • -Set: Changes the physical disk drive state to hotspare for the enclosure.
• -Rmv: Changes the physical drive state to ready (removes the hotspare).