MSI X2-109 v1 - Manual (Page 62)

4-10 MegaCLI Command Tool
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
4.7.2 Configure Each Disk as RAID 0
Use the command in Table 4.12 to configure each physical disk in
Unconfigured-Good state as RAID 0.
Note: The MegaCLI CT does not support spanning across these
single-drive RAID 0 configurations
.
Description Adds a RAID level 0, 1 or 5 configuration to a specified adapter. Even if no
configuration is present, you have the option to write the configuration to the adapter.
• –Rx[E0:Sn]: Used to specify RAID level and physical drive enclosure/slot
numbers for an array.
• –strpszM:: Used (optionally) to specify a stripe size. You can set the stripe size
to 64 Kbytes.
• –Hsp[Ex:Sx,…]: Used to create a global hotspare, with physical drive
enclosure/slot numbers specified. This option cannot be used to create dedicated
hotspares.
• –szXXXX:: Used to specify the size of a logical drive, where XXXX is a decimal
number of Mbytes. However, the actual size of the logical drive may be smaller,
because the driver requires the number of blocks from physical drives in each
logical drive to be aligned to the stripe size. This option can also be used to
create a configuration on the free space available in the array.
• -AfterLdX:: Used to specify which free slot should be used (optional). By default,
MegaCLI CT uses the first free slot available in the array. This option has no
meaning if the array is not already used for configuration.
Table 4.11 Add RAID 0, 1, or 5 Configuration (Cont.)
Table 4.12 Configure Each Disk as RAID 0
Syntax CmdTool –CfgEachDskRAID0 [{WT | WB }] [{NORA | RA | ADRA}] [{Direct
| Cached}] [{-strpszM} -aN|-a0,1,2|-aALL