AMX NETLINX MASTER NXC-ME260 - Manual (Page 13)

Installation and Wiring
9 NXC-ME260 NetLinx Master-Ethernet Card/Module
5-Pin Program port (rear panel)
The table below lists the pinouts and signals for the rear panel Program port connector.
ICSNet RJ-45 Connections/Wiring
The following table shows the pinouts, signals, and pairing information to use for ICSNet RJ-45
connections. The ICSNet connections provide power and data to ICSNet devices. Each port
provides up to 500 mA of current.
ICSHub RJ-45 Connections/Wiring
The two ICSHub RJ-45 connectors on the rear of the Master Card provide data to other Hubs
connected to a downstream system. Hubs allow you to connect multiple NetLinx Hubs together in a
daisy-chain configuration. Connect the OUT port to the IN port on the second or downstream
NetLinx hub.
! Use CAT5 cables for all ICSHub connections.
! Do not connect the last hub in a daisy-chain configuration into the first hub.
5-Pin Program Port Pinouts and Signals
Pin Signal
1 GND
2 RX
3 TX
4 CTS
5 RTS
ICSNet RJ-45 Pinouts/Signals
Pin Signal Connections Pairing Color
1 TX + 1 --------- 1 1 --------- 2 orange-white
2 TX - 2 --------- 2 orange
3 Mic - 3 --------- 3 3 --------- 6 green-white
4 GND 4 --------- 4 blue
5 12 VDC 5 --------- 5 4 --------- 5 blue-white
6 Mic + 6 --------- 6 green
7 RX + 7 --------- 7 7 --------- 8 brown-white
8 RX - 8 --------- 8 brown