Cirrus Logic CS4953xx - Manual (Page 9)

CS4953xx Data Sheet
32-bit Audio Decoder DSP Family
DS705F2 9
4.3.2 Termination Requirements
Open-drain pins on the CS4953xx must be pulled high for proper operation. Refer to the CS4953xx Hardware
User’s Manual to identify which pins are open-drain and what value of pull-up resistor is required for proper
operation.
Mode select pins on the CS4953xx are used to select the boot mode upon the rising edge of reset. A detailed
explanation of termination requirements for each communication mode select pin can be found in the
CS4953xx Hardware User’s Manual.
4.3.3 Pads
The CS4953xx I/O operates from the 3.3 V supply and is 5 V tolerant.
4.4 Application Code Security
The external program code may be encrypted by the programmer to protect any intellectual property it may
contain. A secret, customer-specific key is used to encrypt the program code that is to be stored external to the
device.
5 Characteristics and Specifications
Note: All data sheet minimum and maximum timing parameters are guaranteed over the rated voltage and
temperature. All data sheet typical parameters are measured under the following conditions: T = 25 °C,
C
L
= 20 pF, VDD = VDDA = 1.8 V, VDDIO = 3.3 V, GNDD = GNDIO = GNDA = 0 V.
5.1 Absolute Maximum Ratings
(GNDD = GNDIO = GNDA = 0 V; all voltages with respect to 0 V)
CAUTION: Operation at or beyond these limits may result in permanent damage to the device. Normal operation is
not guaranteed at these extremes.
Parameter Symbol Min Max Unit
DC power supplies: Core supply
PLL supply
I/O supply
|VDDA – VDDIO|
VDD
VDDA
VDDIO
–0.3
–0.3
–0.3
-
2.0
3.6
3.6
0.3 V
V
V
V
Input pin current, any pin except supplies I
in
— +/- 10 mA
Input voltage on PLL_REF_RES V
filt
-0.3 3.6 V
Input voltage on I/O pins V
inio
-0.3 5.0 V
Storage temperature T
stg
–65 150 °C