1 operation flow chart – WIKA CS4R User Manual
Page 10
Operating Instructions Temperature Indicating Controller CS4R
V1.2
•
05/2006
- 10 -
5.1 Operation flow chart
PV/SV display mode
MODE (Approx. 3s)
Control output manipulated
variable indication
MODE
MODE
+ MODE
+ MODE (Approx. 3s)
+ MODE (Approx. 3s)
[Main setting mode] [Sub setting mode] [Auxiliary function setting mode 1] [Auxiliary function setting mode 2]
Set value
[ ]
PID
auto-tuning
Perform/Cancel
[
]
Setting value lock selection
[
]
Input type selection
[
]
MODE MODE MODE MODE
OUT Proportional band setting
[ ]
Sensor correction setting
[
]
Scaling high limit setting
[
]
MODE MODE MODE
Integral
time
[ ]
Communication
protocol
selection [
]
Scaling low limit setting
[
]
MODE MODE MODE
Derivate time setting
[ ]
Instrument number setting
[
]
Decimal point place selection
[
]
MODE MODE MODE
ARW Anti-reset windup setting
[ ]
Data transfer rate selection
[
]
PV filter time constant setting
[
]
MODE MODE
Out Proportional cycle setting
[ ]
Parity
selection
[
]
Control output high limit setting
[
]
MODE MODE
Manual reset setting
[
]
Stop bit selection
[
]
Control output low limit setting
[
]
MODE MODE
Alarm
setting
[
]
Control output ON/OFF action
hysteresis [
]
MODE MODE
Heater burnout alarm setting
[ ]
Alarm action selection
[
]
MODE MODE
Loop break alarm action time
setting [
]
Alarm action Energized/
Deenergized [
]
MODE MODE
Loop break alarm action span
setting [
]
Alarm HOLD function selection
[
]
MODE MODE
Alarm hysteresis setting
[
]
MODE
SVTC bias setting
[
]
Alarm action delayed timer
setting [
]
MODE MODE
Controller/Converter
function
selection [
]
Direct/Reverse action selection
[
]
MODE MODE
Output status selection when
input burnout [
]
AT bias setting
[
]
MODE MODE
•
+ MODE: Press
the
MODE key while the
key is being pressed.
•
+ MODE (Approx. 3s): Press the MODE key while the
key is being pressed.
•
+ MODE (Approx. 3s): Press the MODE key while the
key is being pressed.
For setting and selecting in each setting mode press
or
key.
Dotted lines show options, which are
indicated only when the options are
applied.