WIKA CF2S - Manual (Page 14)

Operating Instructions Temperature Indicating Controller CF2S
V1.2 • 08/2004 - 14 -
(2) Main setting mode
In the PV/SV display mode, if the key is pressed, the Main setting mode will be selected.
The setting value can be increased or decreased by pressing the and
keys.
If the key is pressed, the setting value will be registered and the controller will
revert to the PV/SV display.
PV/SV display mode
Actual Main setting
Temperature value
Main setting
Setting Mode to set the setting value of the main control.
value
Setting range: From Main setting value low limit
to Main setting value high limit
[Factory adjusted as 0°C]
(3) Sub setting mode
In the PV/SV display mode, if the key is pressed while the key is being pressed,
Sub setting mode will be selected.
The setting value can be increased or decreased by pressing the
and keys.
If the key is pressed, the setting value is registered and the next setting item will be selected.
PV/SV display mode
Actual Main setting
temperature value
+
Setting value memory Mode to select the memory number (file)
number selection to be set or to be called.
Selected Selecting items: 1 to 7
value [Factory adjusted as Memory number 1.]
Auto-tuning Mode to designate the auto-tuning Perform or Cancel.
Perform/Cancel If Auto-tuning Perform is designated, and the
Designation key is pressed, the controller reverts to PV/SV display mode.
(When Perform) To set the other values, cancel the Auto-tuning.
When the ON/OFF action or PD action is selected in the
Control action designation (page 10), this display is not available.