WIKA TGT73 - Manual (Page 11)

GB
14028755.02 08/2012 GB/D/F/E
WIKA operating instructions model TGT73 11
The rotational motion is converted into an electrical signal. The
electronics are factory set to the standard 4 ... 20 mA passive or
0 ... 10 V output signal. The span of the electrical output signal
corresponds to the measuring span on the dial.
Through these two standard electrical output signals, this instrument
can be set to almost any range in the industry.
Thermometers from the intelliTHERM range with transmitters
combine all the advantages of a local mechanical display with the
industry‘s requirements for electrical signal transmission and a
modern measured value registration.
Variations in the ambient temperature acting on the case are
compensated for by a bimetal element mounted between the
movement and the Bourdon tube.
Scale ranges with accuracy class 1 per EN 13190
between -200 ... +700 °C
4.2 Scope of delivery
Cross-check the scope of delivery with the delivery note.
5. Transport, packaging and storage
5.1 Transport
Check the gas-actuated thermometer for any damage that may
have been caused by transport. Obvious damage must be reported
immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during
transport (e.g. change in installation site, sending for repair).
4. Design and function / 5. Transport ...