Kramer Electronics VS-162AVRCA - Manual (Page 38)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
MENU Commands Sequence
34
To set the unit to function in the Follow-SYSTEM mode:
1. Press the MENU button twice.
The MATRIX Display shows the message:
Follow the SYSTEM
yes -> TAKE, next -> MENU
2. Press the TAKE button.
The Displays show the messages:
set UNIT follow SYSTEM?
Press TAKE to execute
current:
breakaway
3. Press the TAKE button again.
The MATRIX Display momentarily shows this message, followed by the
status of the switcher and in the STATUS Display the letter “S” is
displayed behind the blinking cursor:
the UNIT is set in mode
FOLLOW system
If the status of the unit differs from that of the other unit(s), set the unit to
the Follow-SYSTEM mode. The MATRIX Display blinks the new status
of the switcher and the TAKE LED blinks. Pressing the TAKE button 1
implements all the changes to the same state as the rest of the system
placing the switcher in the Follow-SYSTEM mode.
To set the unit to function in the Breakaway-from-SYSTEM mode:
1. Press the MENU button twice.
The MATRIX Display shows the message:
FOLLOW the system
yes -> TAKE, next -> MENU
2. Press the TAKE button.
The Displays show the messages:
BREAKAWAY from system?
Press TAKE to execute
current:
follow SYS
3. Press the TAKE button again.
The MATRIX Display shows the message:
the UNIT is set in mode
BREAKAWAY from system
1 Pressing a different button cancels the operation and the switcher will remain in its previous state