Kramer Electronics VS-162AVRCA - Manual (Page 27)

Operating Your Audio-Video Matrix Switcher
23
7.2.3 Switching
You can switch:
One input to one output (see section 7.2.3.1)
Several inputs to several outputs (see section 7.2.3.2)
One input to all outputs (see section 7.2.3.3)
7.2.3.1 Switching one Input to one Output
Pressing an OUT-IN combination when your unit operates in the AT ONCE
mode implements the switch immediately.
To switch one input to one output (AT ONCE mode):
1. Press the appropriate OUT button.
The MATRIX Display shows the 2 blinking digits, representing the
present input number connected to that specific output 1 . If the present
output is clear, the 2 blinking digits 00 appear in the MATRIX Display.
The STATUS Display shows the message:
out # x
Where x is the output number
2. Press the appropriate IN button.
The output switches to the input and the MATRIX Display shows the
Input # instead of the blinking digits.
The STATUS Display momentarily shows the message:
out # x
from in # y
Where x is the output number and y is the input number
Pressing an OUT-IN combination when your unit operates in the CONFIRM
mode (and the TAKE LED is lit), requires user confirmation.
To switch one input to one output (CONFIRM mode):
1. Repeat step 1 above.
2. Press the appropriate IN button.
The MATRIX Display shows the 2 blinking digits, representing the input
number and the TAKE LED blinks.
The STATUS Display shows 2 the message:
1 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9
2 Continuously, within the limit of the timeout (approximately 30 seconds)