Kramer Electronics VS-162AVRCA User Manual
Page 31
Operating Your Audio-Video Matrix Switcher
27
3. Press the TAKE button to confirm the action.
The input is cleared and the TAKE LED lights. The MATRIX Display
does not show any Input # in its place.
7.2.4.2 Clearing several Outputs
To clear several outputs (in the AT ONCE mode):
1. Press the appropriate OUT button.
The MATRIX Display shows the 2 blinking digits, representing the
present input number for that specific output
1
. If the present output is
clear, the 2 blinking digits 00 appear in the MATRIX Display.
The STATUS Display shows the message:
out # x
Where x is the output number
2. Press the OFF button.
The output is cleared and the MATRIX Display does not show any Input
# in its place.
The STATUS Display momentarily shows the message:
out # x
reset
Where x is the output number
To clear several outputs (in the CONFIRM mode (the TAKE LED is lit)):
1. Repeat step 1 above.
2. Press the OFF button.
The MATRIX Display shows the 2 blinking digits 00 instead of the
previous 2 blinking digits and the TAKE LED blinks.
The STATUS Display shows
2
the message:
out # x
reset
Where x is the output number
3. Press the second appropriate OUT button, by repeating step 1 above.
4. Repeat step 2 above.
1 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9
2 Continuously, within the limit of the timeout (approximately 30 seconds)