Kramer Electronics VP-8x8 - Manual (Page 22)

VP-8x8 - Operating the VP-8x8 8x8 VGA/UXGA Matrix Switcher 19
19
2. Press the appropriate INPUT/OUTPUT button (the button # corresponding to
the setup #). If in the Confirm mode, that setup configuration will flash in the
7-segment Display, together with the RCL button and the TAKE button, and
will only be implemented after pressing the TAKE button.
The memory recalls the stored data from that reference.
Tip: If you cannot remember which of the 16 input/output configurations is the one
that you want, set the VP-8x8 to the Confirm mode and manually scan all the
input/output configurations until you locate it.
6.3.3 Deleting an Input/Output Configuration
To delete an input/output configuration, do the following:
1. Press the STO and RCL buttons simultaneously.
Both the STO and RCL buttons flash.
2. Press the appropriate INPUT/OUTPUT button.
This erases that specific input/output configuration from the memory, leaving
it empty and available.
Storing a new configuration over a previous configuration (without deleting it first) replaces the
previous configuration
6.4 Locking the Front Panel
To prevent changing the settings accidentally or tampering with the unit via the
front panel buttons, lock your VP-8x8. Unlocking releases the protection
mechanism.
Nevertheless, even though the front panel is locked you can still operate via RS-232 or RS-485, as well as via
the Kramer RC-IR3 Infrared Remote Control Transmitter
To lock the VP-8x8:

Press the LOCK button for more than two seconds, until the LOCK button is
illuminated. The front panel is locked. Pressing a button will have no effect
other than causing the LOCK button to flash
Warning that you need to unlock to regain control via the front panel
To unlock the VP-8x8:

Press the illuminated LOCK button for more than two seconds, until the
LOCK button is no longer illuminated, the front panel unlocks