Kramer Electronics VP-84ETH User Manual
Page 20
Connecting the RGBHV / Balanced Audio Matrix Switcher
17
6.2 Controlling via RS-232 (for example, using a PC)
To connect a PC to the
VP-88ETH unit
1
, using the Null-modem adapter
provided with the machine (recommended):
Connect the RS-232 9-pin D-sub rear panel port on the
VP-88ETH unit to
the Null-modem adapter and connect the Null-modem adapter with a
9-wire flat cable
2
to the RS-232 9-pin D-sub port on your PC
To connect a PC to the
VP-88ETH unit
1
, without using a Null-modem adapter:
Connect the RS-232 9-pin D-sub port on your PC to the RS-232 9-pin
D-sub rear panel port on the
VP-88ETH unit, as Figure 10 illustrates
2
Female DB9 (From PC)
PIN 4 Connected to PIN 6
PINS 8, 7, 1 Connected together
If a Shielded cable is used, connect the shield to PIN 5
PIN 5 Connected to PIN 5 (Ground)
PIN 3 Connected to PIN 2
PIN 2 Connected to PIN 3
Male DB9
Figure 10: Connecting a PC without using a Null-modem Adapter
1 When connecting a single VP-88ETH unit via RS-232, set the SELF ADDRESS # dipswitches to SELF ADDRESS # 1,
according to Table 4
2 Up to 50 feet of cabling may be used for the RS-232 connection