Kramer Electronics VP-200xlTHD - Manual (Page 14)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-200XLTHD
12
3. Connect the LINE OUT RJ-45 connector on the VP-200XLTHD to the LINE IN
RJ-45 connector on the TP-120 via STP cabling (see Section 8.1 ).
4. Connect the 12V DC power adapter to the power socket on the VP-200XLTHD
and plug the adapter into the mains electricity socket.
5. Connect the other 12V DC power adapter to the power socket on the TP-120, and
plug the adapter into the mains electricity socket.
6. On the VP-200XLTHD, if required, use a screwdriver to adjust the:
ƒ Video output signal level
ƒ Cable compensation equalization level
7. On the TP-120, if required:
ƒ Adjust 1
the video output signal level and/or cable compensation
equalization level
ƒ On the underside, set the H SYNC and V SYNC switches 2
Figure 7: Connecting the VP-200XLTHD
1 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
2 By default, both switches are set down (for normal V SYNC and H SYNC polarity)