Festo Контроллер крайних положений SPC11 - Manual (Page 31)

2. Parameters of the SPC11 for the DGCI or DDLI
2-5
Festo P.BE-SPC11-DGCI-EN en 1406d
2.2 Setting parameters
Warning
Incorrectly set parameters can damage the fixed stops and
the drive.
Always select the amplification and cushioning stages for
the maximum mass load. In case of doubt, set first the
amplification and cushioning stages for the larger mass
load.
The positioning times specified in sections 2.3 and 2.4 as well
as optimum system behaviour can only be achieved if the
installation instructions described in the previous section are
observed. The resulting positioning times depend on the
stroke length actually used and can vary depending on the
direction of positioning.
Further instructions on the amplification and cushioning
stages can be found in the System Manual.
Set the parameters as follows:
1. Use the tables in section 2.3 to ascertain the parameters
valid for your application (amplication stage, cushioning
stage and system parameters).
2. Then set the parameters accordingly. Proceed here as
described in the chapter “Commissioning” in the System
Manual (type P.BE-SPC11-SYS...).