Festo Контроллер крайних положений SPC11 - Manual (Page 11)

Contents and general safety instructions
IX
Festo P.BE-SPC11-DGCI-EN en 1406d
Product-specific terms and abbreviations
The following product-specific abbreviations are used in this
manual:
Term/abbrevi-
ation Meaning
0-signal Input or output supplies 0 V
1-signal Input or output supplies 24 V
Drive The term drive is used in this manual for the linear unit (DDLI, DGCI-... or
DGP(I)(L)-...), cylinder (DDPC, DNC...) or rotary drive (DSMI-...).
O Digital output
Cushioning stage The positioning behaviour is determined by the amplification and cushioning
stages. The cushioning stage serves to optimize the approach behaviour when
moving to the end positions.
I Digital input
PLC/IPC Programmable logic controller/industrial PC
System parameters Characteristic value which describes the system structure, the features and
components of the drive used.
Parameters Parameters which must be set in order that the system can be operated.
The amplification stage, the cushioning stage and the system parameter
belong here.
Teach procedure During the teach procedure the SPC11 checks the set parameters, learns the
position of the mechanical fixed stops as well as various characteristic system
values and saves them in the integrated EEPROM.
Amplification stage The amplification stage influences the acceleration behaviour of the drive,
for example. The amplification stage should usually be set as specified in the
“Drive-Specific Supplement” manual. If the positioning behaviour is optim-
ized later, only the cushioning stage should be modified.