Festo Контроллер крайних положений SPC11 - Manual (Page 15)

1. Installation instructions for the DGCI or DDLI
1-3
Festo P.BE-SPC11-DGCI-EN en 1406d
1.1 General information
Warning
Faults in the system structure and incorrect parameters
can cause the slide to move to an end position uncu-
shioned. The fixed stop or the drive may then be de-
stroyed. You must observe the following instructions
in order to prevent such damage.
• Set up the system with great care. Always observe the
safety instructions and information in this manual as well
as in the system manual for type P.BE-SPC11-SYS... .
• Use only the special matching components from Festo for
setting up and wiring the system. Only in this way can you
be sure that the system will function correctly.
Note
In order to operate the DGCI-... you will require the SPC11
type SPC11-MTS-AIF-2.