Festo Контроллер крайних положений SPC11 - Manual (Page 30)

2. Parameters of the SPC11 for the DGCI or DDLI
2-4
Festo P.BE-SPC11-DGCI-EN en 1406d
Specifications for setting the parameters
In order to set the parameters, you will require the following
specifications:
– the stroke length (see type plate on the drive used)
– the valve type (see type plate on proportional directional
control valve used)
– the maximum mass load with which the drive may be
loaded
Mass load
If you wish to move to a position with different masses:
– Positioning with a mass up to 30% less is usually no
problem. Further reduction of the mass can lead to
a deterioration in positioning behaviour and make
optimization necessary (see System Manual).
– If necessary, place a basic load on the drive in order to set
a higher mass. Positioning can then be made with a
greater difference of mass.
– Always set the amplification and cushioning stages for the
maximum mass load used.