Festo Пневматические линейные приводы SLG - Manual (Page 24)

SLG−...
Festo SLG−... 0802d English
24
Pneumatic fitting
To set the slide speed:
S Use one−way flow control valves of type GRLA−...
These valves control the exhaust directly
in the compressed air connections.
For screwing in directly without one−way flow
control valves:
S Use barbed fittings or screw connections
with small width across flats.
Fittings with large width across flats reĆ
quire too much space for rubing.
S Check whether non−return valves with
triggering type HGL−... are required.
If there is a loss of pressure in cases
where the cylinder is fitted in a vertical
position, non−return valves ensure that
the mass remains in the position reached.
S Select the compressed air connections for
your application:
There are alternative compressed air conĆ
nections (B) to the connections intended
for use (A) when supplied from the facĆ
tory.
These are sealed with threaded pins.
On the alternative connections, the
threaded pins will only seal when new
sealing medium is applied.
S Connect the SLG−... to the compressed air
connections
2.
The assignment of the connecting holes to
the direction of travel of the slide is shown
in Fig. 16.
Fig. 13
Fig. 14
Fig. 15
(A)
(B)
Fig. 16