Muxlab Passive CCTV Hub - Manual (Page 10)

© MuxLab Inc. Passive CCTV Hub Installation Guide
Page 10
Port Switch Settings:
4. For each camera port, determine whether video, power and/or control is to
be transmitted via the same Cat5 cable. If only video is to be transmitted,
then the Power/Control terminals and port switch may be disregarded.
5. In order to transmit video on one (1) twisted pair, remote power on two (2)
twisted pairs and control on one (1) twisted pair, set the port switch to
Pass-Thru Mode (500022) using a small flathead screwdriver, as shown in
fig 6. Ensure that there is a CCTV Pass-Thru Balun (500022) at the
camera.
Figure 6: Port Setting – Pass-Thru Mode (500022)
6. In order to transmit video on one (1) twisted pair and remote power on
three (3) twisted pairs, set the port switch to Power-Thru Mode
(500024/500029) using a small flathead screwdriver (fig 7). Ensure that
there is a CCTV Power-Thru Balun (500024 or 500029) at the camera.
Figure 7: Port Setting – Power-Thru Mode (500024/500029)