RMS Technologies IMD 34 W/ POLE DAMPING TECHNOLOGY*NEW* - Manual (Page 9)

RMS Technologies Page 9 Version 1.00
IMD34 / IMDE34 User Manual 4/28/2009
5
MOTOR MOUNTING SPECIFICATIONS
There are four (4) 0.258” thru holes on the motor flange for mounting the motor to an
adapter plate. Recommended screws for mounting the motor are 0.250” or ¼-20.
Figure 6: Mounting Specifications
Recommended hardware (not included with IMD34)
4 x ¼-20 screw
4 x ¼” Split lockwasher
4 x ¼” Flat washer
4 x ¼-20 lock nuts
Adapter Plate / Mounting
Allow 1.0” to 1.5”
clearance for cables