ADC EMU-830 - Manual (Page 54)

Chapter 3: Provisioning September 25, 2006
3-22 LTPE-UM-3159-02
Reset EMU
In the Config menu, press R to display the "reset EMU" warning prompt ( Figure 3-17 ).
Figure 3-17. Reset EMU Warning Prompt
Do one of the following:
• Press Y (yes) to reset the EMU (then log on to the EMU console menu if you wish to make configuration
changes).
• Press N (no) to return to the Config menu.
Inventory Information Screen
Use the
Æ
arrow key to select Inventory, then press ENTER to display the Inventory Information screen (see Figure
3-18 on page 3-23 ). This is read-only screen providing information about the EMU-830. The data included in the
Inventory Information screen is listed in Table 3-7 on page 3-23 .
!
IMPORTANT
If you reset the EMU-830, all alarm reporting information is lost.
Note: Resetting the EMU will log you off from the EMU console menu and requires that you log on again
on to regain access.