ADC EMU-830 - Manual (Page 40)

Chapter 3: Provisioning September 25, 2006
3-8 LTPE-UM-3159-02
Enabling or Disabling Alarm Reporting
To enable or disable alarm reporting for DSL circuits:
Config Menu
In the Main menu screen, use the
Æ
arrow key to select Config; then press C to display the items in the Config
menu ( Figure 3-4 ). Provisioning of all shelf parameters is conducted from the Config menu. Each menu item is
described in the paragraphs that follow.
Figure 3-4. Config Menu
Network Parameters Menu
In the Config menu, press N to display the Network Parameters menu ( Figure 3-5 on page 3-9 ). This menu is used
to identify and change the EMU network parameters. The Network Parameters menu options are listed in Table 3-5
on page 3-10 .
Step Action
1 In the Main menu screen ( Figure 3-3 on page 3-5 ), type the number 1 in the ENTER SELECTION field
and press ENTER. The Enter line unit number field displays the current line unit selection and Enable or
Disable setting.
2 Enter a line unit number, then use the
Ç
arrow key to select the current Enable or Disable setting.
3 Use the SPACEBAR to select Enable or Disable.
4 Press ENTER to confirm settings.