Mittler Bros Machine & Tool 2500 - Manual (Page 2)

\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\manual\2500 Owners Manual.doc REV.3 11-29-06
- 2 -
SAFETY
The purpose of the safety section of this manual is to inform operators and
maintenance personnel of the precautions to be taken while operating or servicing the
machine. The following are a few basic guidelines to follow, but as with any type of
machinery good judgment and a safe attitude should be applied at all times.
1
Always disconnect power, lock-out and tag-out machine per OSHA regulations before
attempting to service this machine.
2. Always wear safety glasses or other approved eye protection while operating or servicing
the machine.
3. Keep all body parts and any foreign objects away from moving parts. Do not reach into the
machine without first disconnecting all power sources.
4. Do not attempt to override any safety device on the machine.
5. Do not operate the machine if it has been damaged or is not operating properly.
6. Do not wear jewelry (watches, rings, necklaces, etc.), or loose fitting clothing while operating
or servicing the machine.
7. The machine should only be operated or serviced by properly trained, authorized personnel.
8. Replacement parts should have the same specification and operation as the original parts
on the machine.
9. All guards and covers must be in place before operating the machine.
10. Before starting the machine be sure it is set up properly.
11. Make sure the machine is properly grounded.
12. The machine and work area should be kept neat and clean.
13. Do not operate or service any machine while under the influence of drugs or alcohol.
NOTE: THESE SAFETY RULES ARE FOR YOUR BENEFIT TO HELP PREVENT INJURY TO
YOURSELF AND/OR YOUR CO-WORKERS. REVIEW ALL SETUP AND OPERATING
PROCEDURES, WHETHER COVERED OR NOT, IN THIS MANUAL TO HELP INSURE SAFE
OPERATION OF THE MACHINE.
1.800.467.2464 www.mittlerbros.com