Pathway LR Manual - Manual (Page 43)

DMXPathfinder LR Installation & Assembly
42
each module, and use 8-32 screws to attach the rack mount ears to the sides of
each Input and Output Module.
If P2020 type termination boards are to be used, mate them to each
Output Module and fasten with 5 x 6-32 screws.
Using one power cord, power up each Input and Output Module one at a
time and verify that the main power LEDs illuminate.
Remove the four adhesive rubber feet from the bottom of each module.
M
ODULE
I
NSTALLATION
Starting with the last (bottom) Output Module, install the modules into the
equipment rack. Normally the Input Module(s) are located above the Output
Modules, but they can both be placed at the bottom or one at the top and one at
the bottom, if desired. In any case they may not be placed between Output
Modules.