Vaddio HE120 Operating Instructions - Manual (Page 88)

88
Setting/releasing the limiters
(continued)
  Releasing the limiters
The limiter positions that are set can be released by following
the steps below.
When the position is released, the tally lamp blinks twice.
1
Press one of the [CAM1] to [CAM4] buttons to
select the unit.
2
Release the limiters by taking the steps below.
  Releasing the upper limit position of the
movement range
Perform the steps in “Basic limiter operations”.
(Press the [MENU] button quickly and then press
the [
 ] button for 2 seconds while holding down the
[PRESET] button.)
  Releasing the lower limit position of the
movement range
Perform the steps in “Basic limiter operations”.
(Press the [MENU] button quickly and then press
the [
 ] button for 2 seconds while holding down the
[PRESET] button.)
  Releasing the left-most limit position of the
movement range
Perform the steps in “Basic limiter operations”.
(Press the [MENU] button quickly and then press
the [
 ] button for 2 seconds while holding down the
[PRESET] button.)
  Releasing the right-most limit position of the
movement range
Perform the steps in “Basic limiter operations”.
(Press the [MENU] button quickly and then press
the [
 ] button for 2 seconds while holding down the
[PRESET] button.)
  Resetting the limiters
To reset the limiters, the currently established settings must
be released.
The limiter positions that are set can be reset by following the
steps below.
1
Release the settings of the limiter positions to
be reset by following the steps in “Releasing
the limiters”.
2
Set the limiter positions by following the steps
in “Setting the limiters”.