Vaddio HE120 Operating Instructions - Manual (Page 76)

76
Web setting screen
(continued)
Host auth. screen
 Host auth.
Host authorization is set to “On” or “Off” here.
  Select the “Off” setting for no host authentication
when the AW-RP50 remote camera controller is
connected in a network.
Note
 IP address
The IP address of the PC from which access to the
camera is allowed is input here.
The host name cannot be input as the IP address.
  When the “IP address/subnet mask length” is input, the
PCs which are allowed to access the camera can be
restricted on a subnet by subnet basis.
If, for instance, “192.168.0.1/24” has been input and
the “2. Camera control” setting has been selected as
the access level setting, the PCs from “192.168.0.1” to
“192.168.0.254” will be able to access the camera at
the “2. Camera control” access level.
  When an already registered IP address is input and
the Set button is clicked, the host information will be
overwritten.
 Access level
Select one of the following settings as the host access
level.
1. Administrator
2. Camera control
For details on the access level, refer to page 75.
 Host check
A pull-down menu can be opened here, and the IP
addresses of the registered hosts checked.
A host is indicated in the form of “Registered IP address
[Access level]”.
(Example: 192.168.0.21 [1])
To delete a registered host (IP address), select the host to
be deleted, and click the Delete button on the right.