Vaddio HE120 Operating Instructions - Manual (Page 32)

32
Basic operations
(continued)
  Control exercised from the Multi-Function Controller AW-RP655
For executing AWB. *1, *2
Jog dial (main)
When the LCD is in the gain adjustment
mode ([GAIN] button: MANU)
Select the desired gain setting from GAIN
0 dB to 18 dB.
When the LCD is in the gain adjustment
mode ([GAIN] button: AUTO)
Select the desired gain setting from AGC
MAX GAIN 6 dB, 12 dB or 18 dB.
When the LCD is in the pedestal
adjustment mode
Adjust the PEDESTAL TOTAL setting
(–150 to +150).
When the camera menu mode is
established
Perform the camera menu operations.
This is used to acquire the
statuses of the camera and
synchronize the data. *3
For switching White Balance Mode
A, B or ATW.
These are used for menu
operation.
Each time the [EXT(AF)]
button is pressed, the
focus setting is switched
between auto focus and
manual focus.
When auto focus is
selected, the [EXT(AF)]
button lights.
When the focus setting
is switched between auto
focusing and manual
focusing by the camera
menu or by the other
controller, the resulting
status (lamp on or off)
will not be reflected in the
button.
Each time the [MODE] button is pressed, the
setting is switched between CAM and BAR.
The [MODE] button lights up at the BAR setting.
For executing ABB. *1, *5
Jog dial (R)
When the LCD panel is in the gain adjustment mode
Adjust the B GAIN setting (–150 to +150).
When the LCD panel is in the pedestal adjustment mode
Adjust the B PEDESTAL setting (–150 to +150). *6
When the LCD is in the camera menu mode
Press the jog dial (R) to cancel the setting change.
Jog dial (L)
When the LCD panel is in the gain adjustment
mode
Adjust the R GAIN setting (–150 to +150).
When the LCD panel is in the pedestal
adjustment mode
Adjust the R PEDESTAL setting (–150 to +150). *6
This is used to switch between AUTO and
MANU for the gain. The [GAIN] button lights
when the AUTO setting is selected.
The lamp of this button
flashes when an alarm
(Fan Error) has been
received from the
camera. *4
For selecting the cameras to be operated.
*7
*1: The lamp of the AWC or ABC switch flashes while
automatic white balance or automatic black balance
is being executed, respectively. When AWB or ABB
is completed successfully, the corresponding lamp
goes off; when it is not completed successfully, it
lights up.
*2: The switch lights without AWB being executed when
the white balance mode of the main unit is ATW,
3200K, or 5600K, or when the Color Bar is being
displayed.
*3: SCENE FILE, CAM/BAR, and GAINUP of each
SCENE, as well as the W/B MODE, R/B GAIN and
T/R/B PED statuses are synchronized.
*4: Flashing stops when communication is
disconnected because the OPERATE switch has
been turned OFF, CAMERA SELECT has been
switched, the communication cable has been
disconnected, etc.
*5: The switch lights without ABB being executed when
the Color Bar is being displayed.
*6: The R/B GAIN adjustment is not available when the
White Balance Mode is set to ATW, 3200K, or 5600K.
*7: The ND button cannot be used.
Perform the operations using the camera menu.